EasyManua.ls Logo

NuWave OXYPURE ZERO E1000 - Cleaning and Maintenance

NuWave OXYPURE ZERO E1000
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 | OxyPure Zero E1000
CLEANING & MAINTENANCE
FILTER CLEANING TIPS AND TRICKS
Over time, the lters in your OxyPure can get caked with dust, pollen, pathogens
and other contaminants that can be accidentally inhaled or released into the air
ifthe lters are not handled properly during cleaning.
Indoor vs. Outdoor Filter Cleaning
Ideally, you should clean your lters outdoors, where you will have access to a water hose
(DO NOT USE A PRESSURE WASHER) that will allow you to clean the lters from a
distance while eliminating the possibility of reintroducing trapped contaminants back into
your home. Outdoor cleaning, however, is not always practical due to weather or property
issues (i.e., you live in an apartment), so you will have to clean your lters indoors. It is not
difcult, and to make it even easier and more effective, here are some general and lter-
specic cleaning tips.
General Tips
1. Always Wear a Mask
This will prevent accidental inhalation of any contaminants when cleaning your
lters.
2. Move the OxyPure, Not the Filters
Move the OxyPure as close as possible to the location where you will clean the
filters. This will minimize the chance of the filter being shaken (see 3, below).
3. Handle the Filters Carefully
As you remove the lters from the unit, be careful not to shake, drop, bump, or
otherwise agitate them as doing so can cause the release of trapped contaminants.
4. Dry the Filters Completely
Never install a wet or damp lter into your OxyPure as doing so will interfere with the
lter’s function.
5. Clean the Louvers
Raise the louvers to a 90 degree angle and then unplug the OxyPure. That will keep
them vertical while you wipe them down on each side with a warm, damp cloth. Plug
the OxyPure back in and allow them to come down again.
Filter Maintenance
When maintaining the lters, unplug the unit and open the Filter Access Panel. You will
see that the order of the lters, from the outside in, is as follows:
1. 2 Stainless-Steel Prelters (Filter 1)
2. 2 Bio-Guard
®
Filters (Filter 2)
3. 2 Ozone Emission Removal Filters (Filter 3)
4. 1 Bio-Guard
®
360 Filter (Filter 4)

Other manuals for NuWave OXYPURE ZERO E1000

Related product manuals