NuWave OXYPURE ZERO E1000 - Filter Changing Precautions; Electrical Information and Safety

nuwavenow.com | 5
SAFEGUARDS & INFORMATION
HOUSEHOLD USE ONLY • READ ALL INSTRUCTIONS BEFORE USE
FILTER CHANGING PRECAUTIONS
1. DO NOT try to clean the HEPA/Carbon lters. Doing so will release dust and other pollutants back
into the air. The mesh Prelters may be washed in warm, soapy water, but must be dried before
being reinstalled.
2. ALWAYS use rubber gloves when handling the lters.
3. When removing dirty lters, ALWAYS do so outside or in a well ventilated area.
4. ALWAYS replace your lters with NuWave lters made for your model of air purier.
ELECTRICAL INFORMATION
These servicing instructions are for use by qualied personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that contained in the operating instructions unless you
are qualied to do so.
Power-Supply Cords
A short, detachable power-supply cord is provided to reduce the risk of becoming entangled in, or trip-
ping over, a longer cord. Longer detachable power-supply cords or extension cords are available and
may be used if care is exercised in their use. If a longer, detachable power-supply cord or extension
cord is used:
1. The marked electrical rating of the extension cord should be at least as great as the electrical
rating of the appliance.
2. The longer cord should be arranged so that it will not drape over any countertop or tabletop where
it could be pulled on or tripped over unintentionally.
3. The OxyPure should be operated on a separate electrical outlet from other operating appliances
due to wattage limitations.
24. Inspect the OxyPure for any loose or missing parts before and after each use. If parts are loose,
damaged, or missing, contact Customer Service at 1-877-689-2838 or email help@nuwavenow.
com.
25. DO NOT pull, lift, drag, pick up, or carry the OxyPure by its cord.
26. DO NOT block the air inlet or outlet vents.
27. DO NOT operate the OxyPure without lters or the Filter Access Panel in place.
28. DO NOT place anything with a strong odor or chemical on or close to the odor sensor.
WARNING
RISK OF ELECTRIC SHOCK: To reduce the risk of electric shock, this equipment has
a polarized plug (one blade is wider than the other). This plug will t in a polarized outlet
only one way. If the plug does not t fully in the outlet, reverse the plug. If it still does not t,
contact qualied personnel to install the proper outlet. Do not alter the plug in any way.
These servicing instructions are for use by qualied personnel only. To reduce the risk
of electric shock, do not perform any servicing other than that contained in the operating
instructions unless you are qualied to do so.