Nvidia Mellanox ConnectX-6 Dx Series - Unpacking the Package; Pre-Installation Checklist

21
1.
2.
3.
Unpacking the Package
Check against the package contents list that all the parts have been sent.Check the parts for visible
damage that may have occurred during shipping. Please note that the cards must be placed on an
antistatic surface.
Category Qty. Item
Cards 1 ConnectX-6 Dx adapter card
Accessories 1 Adapter card short bracket
1 Adapter card tall bracket (shipped assembled on
the card)
Pre-Installation Checklist
Verify that your system meets the hardware and software requirements stated above.
Shut down your system if active.
Turn off the power to the system, and disconnect the power cord. Refer to the system
documentation for instructions. Before you install the ConnectX-6 Dx card, make sure that the
system is disconnected from power.
(Optional) Check the mounting bracket on the card.
If required for your system, replace the full-height mounting bracket that is shipped mounted on
the card with the supplied low-profile bracket. Refer toBracket Replacement Instructions.
Please note that if the card is removed hastily from the antistatic bag, the plastic ziplock may
harm the EMI fingers on the networking connector. Carefully remove the card from the
antistatic bag to avoid damaging the EMI fingers.
