NXP Semiconductors S32K344 - Page 8

NXP Semiconductors
S32K344
White Board
MMA8452 (Accel Sensor, address
0x1D)
SGTL5000 (Audio Codec, address
0x0A)
CS2100 (Clock Multiplier, address
0x4F)
I2C LPI2C0 (3.3V) Enabled
FRAM (Fast EEPROM, address 0x57)
CAN_0 TJA1044_1 PTA7_CAN0_TX, PTA6_CAN0_RX
CAN_1 TJA1044_2 PTA23_CAN1_TX, PTA22_CAN1_RX
CAN_2 TJA1145_1 PTD18_CAN2_TX, PTD19_CAN2_RX
CAN_3 TJA1145_2 PTE28_CAN3_TX, PTE29_CAN3_RX
CAN
CAN_4 IO Header PTG8_CAN4_TX, PTG9_CAN4_RX
LIN1 SJA1124_LIN1
LIN2 SJA1124_LIN2
LIN3 SJA1124_LIN3
LIN4 SJA1124_LIN4
LIN Controller and Phy controlled by
LPSPI3 with PCS0.
LIN5 TJA1124_LIN1 PTF2_LPUART6_TX,
PTF3_LPUART6_RX
LIN6 TJA1124_LIN2 PTF18_LPUART7_TX,
PTF19_LPUART7_RX
LIN7 TJA1124_LIN3 PTF23_LPUART9_TX,
PTF24_LPUART9_RX
LIN
LIN8 TJA1124_LIN4 PTF16_LPUART12_TX,
PTF17_LPUART12_RX
LPUART0 PTA27_LPUART0_TX,
PTA28_LPUART0_RX
LPUART2
CP2104 USB2
UART
PTE12_LPUART2_TX,
PTD17_LPUART2_RX
UART
LPUART1 Ext 4G Module PTB22_LPUART1_TX,
PTB23_LPUART1_RX
Audio SAI0 Enabled SGTL5000 Audio Codec
SW2 PTC20 (high active)Push Buttons
SW3 PTC21 (high active)
POT1 PTB13 (ADC0_S8)ADC POT
POT2 PTB14 (ADC0_S9)
LED D28 PTF8 (high active)
LED D29 PTF9 (high active)
LED D30 PTF10 (high active)
LED D31 PTF11 (high active)
User
Peripherals
User LEDs
LED D44 PTG0 (low active)
Table 6. White Board resources mapping...continued
UM11919 All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
User manual Rev. 1.0 — 11 April 2023
COMPANY PUBLIC 8 / 32