VALVE ADJUSTING
Valve clearances are correctly set before any
O.S. engine leaves the factory and, in normal
use, will seldom require adjustment. However,
if, after a very considerable amount of running
time has been consumed, a loss of power is
detected, or if he engine has been
disassembled for repair, these clearances
should be checked and reset as necessary.
For checking and adjusting the valve
clearances, VALVE ADJUSTING TOOL KIT is
available as an optional accessory.
The kit comes in a plastic case and includes:
(Code No.72200060)
• Feeler gauge 0.04mm
• Feeler gauge 0.1 mm
•
Hex. key 1.5mm
• Wrench 5mm
34
To Next Page
Loading...
