Instruction Manual CON 6/TDS 6
26
C°
Select Normalization Temperature. Choice of
either 20 °C or 25 °C.
Default value is 25 °C.
Adjust TDS factor from 0.4 to 1.0.
Default value is 0.5. (Available in TDS 6
meter only)
Select Single Point Calibration. Choice of
“Yes” or “No”.
Default value is “Yes”.
User re-set to factory defaults. Choice of “Yes”
or “No”.
Default value is “no”.
Overview of Advanced Setup
To Next Page
