To Next Page

To Previous Page

Formaximumefciencyandperformance,yourwaterdispenserrequirescleaningonaregularbasis(ie.every6

months). Regular cleaning will prevent potential growth of bacteria and will maintain a hygienic environment.

Never use harsh chemicals or abrasive cleaners.

Cleaning the Outside of the Water Dispenser

The outside of the dispenser may be wiped clean with a cleaning solution product or a mild soap and water mixture and

a soft cloth. Rinse thoroughly with clean water and dry.

Cleaning the Drip Tray

The drip tray should be emptied and cleaned regularly to remove spotting and any mineral deposits.

To remove the drip tray, lift the tray upward, dislodging it from the guides. Drain and clean with cleaning solution or a

mild soap and water mixture. For tough deposits, add vinegar and let it soak until the deposits loosen. Then wash, rinse

and dry throughly. Replace the grill on the drip tray and slide it onto the guides.

Cleaning the Condenser

Vacuumorsweepawaythedustfromthecondensercoils.Thiswillimprovecoolingandefciency.

Cleaning The Waterways

IMPORTANT: TURN OFF THE HOT AND COLD WATER SWITCHES BEFORE PERFORMING THIS PROCEDURE.

1. Make sure the power cord is plugged into an electrical outlet.

2.Openthelowercabinetdoor,pullthebottleforwardoutofthedispenserandplaceontheoor.

3. Remove the water bottle cap and siphon tube from the bottle and hang on the hook located on the inside of the

lower cabinet door. Be sure to keep the door open so that the water pump does not run. For bottle-less cleaning, re

peatthisprocedurebutipthewatersupplyswitchto“BOTTLE”duringthisprocedure.

4. Drain the cold reservoir by placing a container under the water dispense point and pressing the cold dispense

buttonuntilwaterstopsowing.Discardwater.

5. Using a clean container, mix 8 cups (2 L) of white vinegar with 8 cups (2 L) of hot water. Place the container inside of

the bottle storage compartment. Insert the siphon tube into the cleaning solution, keeping the container

upright, and close the lower cabinet door. The water pump will start automatically and run for several minutes to

draw the cleaning solution into the dispenser reservoirs. Once the pump has stopped, dispense 0.5 cups (0.12 L) of

water from each of the 2 dispense buttons. Allow the cleaning solution to sit inside the dispenser for 20 minutes.

6. Place a container under the water dispense point and press the hot and cold water dispense buttons

untilthecleaningsolutionstopsowing.Discardcleaningsolution.Thepumpwillcontinuetooperatefor

approximately30seconds,followedbyaashingyellowbottleemptylight.

7. Using a container, drain the remaining cleaning solution from the internal hot and cold tanks by unscrewing the hot

tank drain cap located at the back of the dispenser. Discard the cleaning solution. Re-install the hot tank drain cap.

Repeatforcoldtankdrain.RefertoPage11and12,“DrainingtheReservoirs”fordetailedinstructions.

8. Flush out the cleaning solution by repeating Steps 5-7 using 16 cups (4 L) of fresh hot water (no cleaning solution).

The cleaning process is now complete.

9.ReplacethewaterbottleoriptheswitchbehindtheunitbacktoPOU.(SeeINITIALSET-UP)

NOTE: To conserve energy when not using the dispenser for a long period of time, unplug the dispenser and drain the

reservoirs.

CLEANING AND MAINTENANCE

Oasis MAXXFILL FLEX User Manual

Questions and Answers: