Oberheim OB-SX - Initial Setup

INITIAL SETUP
To get started with your OB-SX, do the following:
1) First, make sure the 115/230 switch on the rear panel is
set for the local AC power;
2) Apply power and plug into your sound system;
3) Press "AUTO11 to tune all the oscillators;
4) Select a programmed sound by pressing a GROUP (A thru C or
any combination) and a PROGRAM (1 thru 8);
5) Play!
The OB-SX comes from the factory pre-programmed with 56 patches.
These include a great variety of sounds which can be modified with
the front panel controls to further increase the capabilities of your
instrument•
You can adjust the output volume of the QB-SX with the VOLUME
control on the left hand side of the control panel. This controls
the master volume of all the synthesizer voices. The instrument can
also be fine-tuned to other instruments by using the MASTER TUNE knob
on the back panel of the unit. When this control is within the "dead-
zone" near the top center, the instrument is tuned to standard A-440
pitch.
SELECTING A PROGRAM
The programs on the OB-SX are divided into 7 GROUPS of 8 PROGRAMS each.
The 7 GROUPS are selected by pressing the three GROUP buttons ("Aff,"Bff,
& "C") individually OR in any combination ("ABff ,"ACfl,"BC","ABC").
The PROGRAM within the selected GROUP is then selected by pressing one
of the eight PROGRAM buttons. The PROGRAM button may be pressed at any
time—before, after, or at the same time as the GROUP button—but the
GROUP button or buttons must all be held down AT THE SAME TIME, like
playing a chord.
-2-
Scan by Manual Manor
http://www.markglinsky.com/ManualManor.html