www.discovermymobility.com
- 9 -
25. Adjusting the width and height of the armrest as needed:
Normal state
The gradienter does not work.
Working
Click on the button to ON and the green light is
lighted.The gradienter in normal operation.
Reset automatically
If the gradienter detect the maximum crawl angle,
it will stop working and the green light went out.
Just click to OFF and wait for 2 seconds, then
click the button to RST, the red light is lighted,
The gradienter will reset automatically, the chair
will reset to horizontal position.
Working again
Click to OFF and wait for 2 seconds, then click on
the button to ON, the green light is lighted, the
gradienter in normal operation station again.
To Next Page
Loading...
