EasyManua.ls Logo

Observer Viking 4X4 - Battery Replacement

Observer Viking 4X4
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.discovermymobility.com
- 30 -
44. Battery Replacement
1. Place the batteries back into the power base from the rear base.
2. Fasten the battery strap around the rear battery.
3. Connect each battery harness to his mating plug on the power base.
4. Reinstall the rear cover and the front cover.
5. Charge the batteries.
All batteries being taken out(as
shown),disconnect the
connecting line and install them
on the new batteries,Repeat the
above steps in opposite way
and install batteries,you have
complete it.
Replacing batteries steps
First,screw off the four thumb
screws back of the wheel cover,
and lift up back cover
gently,then loose the batteries
belt,and disconnect the batteries
fastener, last take out the first
battery.
see picture
Push the batteries back from the
front,until the second batteries
to the position of the first
one.disconnect the positive wrie
with a small screwdriver,then
take the second battery.Do the
same and disconnect the third
negative wire, then take out all
the batteries.
as shown

Related product manuals