www.discovermymobility.com
- 39 -
periods of prolonged storage.
Lifting the frame of the Recreational Vehicle to raise the wheels off of the
ground during periods of prolonged storage will eliminate flat spots from
developing.
48.1 Cleaning and Disinfection
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and
metal parts of your electric Recreational Vehicle. Avoid using products that
may scratch the surface of your electric Recreational Vehicle. If necessary,
clean your product with an approved disinfectant. Make sure the disinfectant is
safe for use on your product before application. WARNING! Never use any
chemicals to clean a seat, as they may cause the seat to become crack. Use
soapy water and dry the seat thoroughly.
48.2 Wheel Replacement
If your chair is equipped with a solid tire insert, then you must replace the
whole wheel assembly；If your chair is equipped with a beach tire, which
maximum charge pressure or pressure range is 2Kpa.when you replace the
beach tire to solid tire, you must exchange the whole wheel assembly.
Follow The Steps Below:
1. Turn off the power to the controller.
2. Set the electric Recreational Vehicle up on blocks.
3. Remove the drive wheel nut and washer from the axle.
4. Pull the wheel off the axle.
5. Slide new wheel back on the shaft. Make sure that the key is in the axle slot.
To Next Page
Loading...
