www.discovermymobility.com
- 26 -
42. Getting Ready to Drive Your Viking 4X4
Operate the On/Off switch. The screen will go through an initializing process
then show the base screen as follows.
In the case on an LED Joystick Module the battery gauge will illuminate.
Check that the Speed Setting is at a level that suits you. Push the joystick to
control the speed and direction of the Recreational Vehicle.
If you push the joystick before or just after you switch the control system
on, the screen will flash the joystick displaced screen. You must release
and center the joystick to resume normal operation. If you do not release
the joystick within five seconds the Recreational Vehicle will not be able
to move, even if you release the joystick and push it again. The screen
will display the diagnostic screen at this time. You can reset this
condition by switching the control system off and on again.
Joystick lead
If for any reason, the joystick lead is disconnected take care when reconnecting, do not
force the plug into the socket. The lead is polarized and should only be fitted one way.
To Next Page
Loading...
