MENU: CUES
A cue is a full static snapshot of all DMX values of all ports. The
device supports 99 cues with fade and hold times, plus a link
option to loop multiple cues together. This allows small “mini”
cuelists to be created. Cues are used for standalone operation,
as a backup for signal loss or can be assigned to one of the
switch inputs. This is often used for fire alarm situations where a
system has to go to a defined state and stop all console playback.
Cues can be sent as Ethernet Universes so one device can drive
many other Netron nodes.
Save all values on all ports to a cue slot
Set the fade time of the cue
Set the time to hold the cue until the next cue is started
Cue data is not sent over Ethernet
Cue data is sent on the Universe number and protocol
assigned to the ports.
To Next Page
Loading...