MENU: SYSTEM
This menu contains all the settings to configure and manage the
device.
Set an optional device ID
Display stays on indefinitely
Display goes dark after this time
Adjust the brightness of the internal display
Adjust the brightness of the front LEDs. Set to 0 to
disable them.
The display shows port and connectivity information
The display shows a list of stored cues which can
easily be browsed and started by the encoder wheel
The device does not require a pin
The device asks for a pin after the display times out
Lock the device immediately
Run a specific Cue at startup
No DMX is sent until valid data is received for the
ports. The last incoming values continue to be sent on
the ports until the time is expired. Once timeout has
completed the device will perform one of the below
actions
Forever, 0s, 10s, 30s,
1m, 5m, 10m, 60m
The last incoming values continue to be sent on the
ports until the time is expired. Once timeout has
completed the device will perform one of the below
actions.
Crossfade to DMX 0. Set to 0s for instant out.
DMX traffic is turned off on all ports
Save current configuration including all cue data
Reload configuration. Backups can be exported and
imported from the web interface
Disables RDM processing on the device
Enables all RDM processing on the device
Device will be
reset to factory
defaults.
Yes/No
Reset the device to factory default. It will reload
NETRON Preset 1. All cues are deleted, and all
settings are set to default.
To Next Page
Loading...