OBZ M60 - End Character; Prefix Setting

18
Eg: Add prefix "A”
Step 1: Scan above code to enter into “Add Prefix”;
Step 2: Scan above code to add “Prefix”;
Step 3: Scan the numeric code correspond to “A”, the
ASCII value of A in Hexadecimal is “4” “1”
(Refer to Appendix 1 & Appendix 2);
Step 4: Scan “saved” code to save (Refer to Appendix 1).
PrefixAdd Prefix
Prefix Setting
CR(default)
CR&LF
End Character
None
TAB
Enable
Disable(default)
Enable
Disable(default)
5-bit Additional Code for UPCA
2-bit Additional Code for UPCA