5
I II
USB Receiver Pairing Instructions
Step 1:
Method 1: Press and hold the button for 8 seconds
until the scanner LED1 indicator flashing, it enters
pairing state.
Method 2: Scan below pairing code I and code II in
sequence, the scanner LED1 indicator flashing, it
enters pairing state.
Step 2:
Then plug the USB receiver into the computer USB
port, the scanner LED1 indicator is always on,
indicating that pairing is complete.
Step 3:
Open notepad or other text on the device, use the
scanner to scan compatible barcodes, the barcode
data can be output on it.
Note:
1. After scanning the pairing codes /or long press
button enter pairing state, please insert USB receiver
into computer within one minute. If the pairing is not
completed in one minute, you need to scan the pairing
codes /or long press button again for pairing.
2. At a same time only one device can be connected.
If you need to connect to another Bluetooth device,
please turn off the Bluetooth of the original device first
and unplug the USB Receiver.
Bluetooth Pairing Instructions
Step 1:
Method 1: Press and hold the button for 8 seconds
until the scanner LED1 indicator flashing, it enters
pairing state.
Method 2: Scan below pairing code I and code II in
sequence, the scanner LED1 indicator flashing, it
enters pairing state.
Step 2:
Open Bluetooth on the mobile device and search for
"R&B40" and click pairing. The scanner LED1
indicator is always on, indicating that pairing is
complete.
To Next Page
Loading...