Consumables, supplies and maintenance materials
WARNING
• Do not throw contaminated parts or parts containing toner or ink into an open flame.
• Do not leave parts containing toner or ink or contaminated parts within easy reach of
children.
CAUTION
• Always use the materials which the manufacturer recommended and which are developed
for this machine. Materials not approved by the manufacturer may result in faults in your
machine.
Moving the machine
WARNING
• Make sure that you disconnect the power cord and other cables before you move the
machine.
• Make sure that you check the documentation for the correct machine location before you
move the machine.
• Make sure that whenever the machine is moved, this is done by properly qualified people
who have received adequate instructions.
General use
WARNING
• Do not lean, lie or stand on any part of the machine, including any unit that can be pulled
outward (e.g. paper drawers).
• To prevent overbalance of the machine, only one drawer should be opened at the same time.
CAUTION
• The left cover must be closed during normal operation. This is necessary to ensure proper
operation.
• Turn off the machine before opening the fuser.
• The fuser must be closed during normal operation. The fuser may only be opened to remove
paper after a paper jam. Because of hot surfaces, the operator must always be cautious and
wear heat-protective gloves when removing material in the fuser section.
• If the printer is not equipped with the optional roll loader, the NIOSH limit value for handling
loads will be exceeded if rolls of imaging materials having a net weight of more than 7 kg/
15.4 lbs (i.e. a width of more than approx. 50 cm or 20 inches) are placed in roll position
numbers 2, 4 and 6 by only one person.
IMPORTANT
• Unplug the product when you will not use it for a long period of time.
Safety information (all countries)
10
Chapter 1 - Safety information
To Next Page
Loading...
