EasyManua.ls Logo

Ocean Technology Systems PowerCom 3000D - Troubleshooting Guide

Ocean Technology Systems PowerCom 3000D
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
OTS POWERCOM
TROUBLESHOOTING GUIDE

Issue Step 1 Step 2
No/Low Transmit
Change E/M to isolate issue
Contact OTS.
Change E/M Adapter
Move Mic Close to lips
Ensure Transducer is not
covered by equipment
Change Transducer
No Receive Volume
Change E/M to isolate issue
Contact OTS.
Change E/M Adapter
Ensure Transducer is not
covered by equipment
Change Transducer
Reduce distance to divers
Scrambler setting “stuck Contact OTS.
Transmission setting
stuck” on PTT
Contact OTS.
No Side Volume Contact OTS.
Charger LED illuminates
green but the unit LED
does not activate
Contact OTS.
Charger LED illuminates
green, unit LED illuminates
red, but the unit will not
activate when submerged.
Battery is “dead”. Replace
the battery. Contact OTS.
Short Battery Life when
fully charged
Replace the battery.
Flooding in battery com-
partment
Replace the battery. (See page iv for safety warning on
handling a ooded battery compartment)
Flooding in electronics
compartment
Do not attempt to power on the unit. Contact OTS.
Unit LED activates with
no start up volume and no
transmit or receive
Contact OTS for replacement

Related product manuals