EasyManuals Logo

Oceanic OCS90 Manual

Oceanic OCS90
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
April ‘13
Oceanic Sauna Heater Manual
Thank you for choosing to buy our Oceanic Sauna heater; please take the time to read
these instructions before you begin as they contain important information about the
installation and maintenance requirements.
“Oceanic” sauna heaters are available in specifications from 3kw to 9kw and are
equipped with our OC-SA digital controller. With this not only can you control the temperature and time
duration of your sauna bath but also the light of the sauna room, alter the temperature display between
Centigrade and Fahrenheit; as well as displaying the sauna heater’s status.
Every “Oceanic” sauna heater is thoroughly tested before leaving the factory.
IMPORTANT
Read the manual before installation and operation and then keep it for reference
This equipment must be installed by competent person
This equipment must be connected to an all pole isolator of the correct rating
Disconnect the power supply before exposing electrical connections
All heaters can be connected single phase(230v) or triple phase(400v), this can be easily changed by
adding bridge connectors across the connections L1, L2 and L3.
5 core silicon bound heat proof cable must be used to wire from the control to the heater. (For 230v and
400v) Wire the letters with the corresponding letters on the heater. For example: U V W on the control
go to U V W on the heater, the three lives for the elements, the reason for having three is because each
element is controlled individually. When the heater reaches the desired temp it cuts out two elements.
The sauna heater should not be used for any other purpose
Do not cover the heater or allow contact with flammable materials such as toweling – Risk of fire.
Do not operate sauna heater without sauna stone
Do not touch the heater when operational as it is very hot
Sauna heater must have right earth connection, the earth wire should be bigger than the power supply
wire to sauna heater
The sauna controller should be installed on a dry wall outside the sauna cabin

Other manuals for Oceanic OCS90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oceanic OCS90 and is the answer not in the manual?

Oceanic OCS90 Specifications

General IconGeneral
BrandOceanic
ModelOCS90
CategoryHeater
LanguageEnglish

Related product manuals