EasyManuals Logo

Oceanic OCS90 Manual

Oceanic OCS90
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Oceanic Sauna Heater
9
Chapter Three: installation
1. Important
Confirm the model you have selected is suitable for your sauna room, please refer to chart 7
Ensure the power supply is suitable for the sauna heater
Isolate the power supply before installation
The installation position must comply with the minimum distance in chart 7; also consider the safety
and convenience (chart 8)
The minimum height of your sauna room must be 1900mm, please refer fig 7C
Do not install the sauna heater on the floor or in a cabinet
Do not cover the sauna heater back with asbestos cement or similar material
The wire which enters the sauna room must be type 60245 IEC 66 HO7RN-F (BSEN 6141) please
refer to chart 7
Do not install two or more sauna heaters in one sauna room.
The sauna heater becomes very hot when operating and must be guarded to protect incase of
accidental contact, please see the sizes in fig 7D and also refer to charts 7 & 8
The upper supporting screws must be fixed tightly, there is a 3mm gap between the screw head and
wall (refer fig 4A, fig 4B), additional retaining screws should be inserted into the round holes to prevent
the heater being lifted.
The sauna controller should be installed on a dry wall outside the sauna cabin
The controller should be kept at a height of between 1200MM-1500MM so that it is easily controlled
and operated
Temperature sensors should be installed in sauna room but not directly above sauna heater, the height
should be 1500-1800mm from floor. The horizontal distance to sauna heater should exceed 500mm

Other manuals for Oceanic OCS90

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oceanic OCS90 and is the answer not in the manual?

Oceanic OCS90 Specifications

General IconGeneral
BrandOceanic
ModelOCS90
CategoryHeater
LanguageEnglish

Related product manuals