Oceanic OCS90 - 7.4. Installing the temperature sensor; 8. Sauna heater, controller and temperature sensor connection drawing

Oceanic Sauna Heater
14
target temperature, all heat elements will work again.
• Light button: Turns sauna light on/off
• Use temperature switch button to change the temperature display between centigrade and Fahrenheit
• The Controller has a timing device so you can set a time when you want the heater to power up, this
can be set from 0~12 hours as shown in the Chart 9 below. When the controller is in B Model (Timer
mode) the heater can’t operate, but when B Model reaches “0” or the “Model Button” is pressed the
heating function will start (A Model). This is explained more at the bottom of this page.
Chart 9
Model Default model
Default Temp Temperature adjust scope
o
C
o
F
o
C
o
F
OC-SA I
OC-SA II
A 75 167 50~110 122~230
A 75 167 50~110 122~230
Default time Time adjust scope
Working time Waiting Work time Waiting time
2 hours 4 hours 30 minutes~6hours 0~12 hours
The time adjustment difference for every
press
The temperature adjustment difference for
every press
10minutes 1
o
C/2
o
F