Oceanic VT Pro - Set ATRBG Alarm

35
Setting TLBG Alarm (continued) -
• Press Both buttons simultaneously, release when SET: 2
appears (4 seconds).
• Press and release the Front (Advance) button, the Units screen
appears with the set point flashing.
• Press the Front (Advance) button 8 more times.
• The graphic ndc and Alarm (speaker) icon appear with the
TLBG Alarm value flashing (Fig. 36).
• Press and release the Side (Select) button to decrease the
number of segments one at a time.
• Press the Front (Advance) button to accept the setting and
advance to Set Air Time Remaining Alarm, or press and hold
Both buttons for 2 seconds to revert to Surface Mode.
TO SET - ATRBG ALARM (while in the Surface Mode)
Factory set for 5 minutes, the Air Time Remaining Bar Graph
(ATRBG) Alarm can be set to values of 0, 5 to 60 minutes in
increments of 5 minutes.
• Press Both buttons simultaneously, release when SET: 2
appears (4 seconds).
• Press and release the Front (Advance) button, the Units screen
appears with the set point flashing.
• Press the Front (Advance) button 9 more times.
• The graphic Atr, and Alarm (speaker) and Cylinder icons
appear with the ATRBG Alarm value flashing (Fig. 37).
Fig. 36 - Set TLBG Alarm
ATR
O
2
Fig. 37 - Set ATRBG Alarm
ATR
5
10
20
30
40
50
60
0
O
2