36
Setting ATRBG Alarm (continued) -
• Press and release the Side (Select) button to decrease the
Alarm value in increments of 5 minutes. Or press and hold to
scroll.
• Press the Front (Advance) button to accept the setting and
advance to Set Turn Pressure Alarm, or press and hold Both
buttons for 2 seconds to revert to Surface Mode.
TO SET - TURN PRESSURE ALARM (while in Surface Mode)
Factory set for OFF (disabled), the Turn Pressure Alarm can be
set to values between 1000 and 3000 PSI (69 to 205 BAR) in
increments of 250 PSI (17 BAR).
• Press Both buttons simultaneously, release when SET: 2
appears.
• Press and release the Front (Advance) button, the Units screen
appears with the set point flashing.
• Press the Front (Advance) button 10 more times.
• The graphic trn and Alarm (speaker) icon appear with the
Turn Pressure Alarm value flashing (Fig. 39).
• Press and hold the Side (Select) button to scroll through the
Alarm values in increments of 250 PSI (17 BAR).
• Press the Front (Advance) button to accept the setting and
advance to Set End Pressure Alarm, or press and hold Both
buttons for 2 seconds to revert to Surface Mode.
Fig. 39 - Set Turn Pressure
Alarm
ATR
PSI
O
2
To Next Page
Loading...
