37
TO SET - END PRESSURE ALARM (while in Surface Mode)
Factory set for 300 PSI, the End Pressure Alarm can be set to
values between 300 and 1500 PSI (20 to 104 BAR) in increments
of 100 PSI (7 BAR).
• Press Both buttons simultaneously, release when SET: 2
appears (4 seconds).
• Press and release the Front (Advance) button, the Units screen
appears with the set point flashing.
• Press the Front (Advance) button 11 more times.
• The graphic End and Alarm (speaker) icon appear with the
End Pressure Alarm value flashing (Fig. 40).
• Press and hold the Side (Select) button to scroll through the
Alarm values in increments of 100 PSI (6 BAR).
• Press the Front (Advance) button to accept the setting and
advance to Set Dive Time Remaining Alarm, or press and
hold Both buttons for 2 seconds to revert to Surface Mode.
TO SET - DIVE TIME REMAINING ALARM
(while in the Surface Mode)
Factory set for 5 minutes, the Dive Time Remaining Alarm can be
set to values between 0:00 and 0:20 (minutes) in increments of 1
minute.
Fig. 40 - Set End Pressure
Alarm
ATR
O
2
BAR
To Next Page
Loading...
