81
Surfacing from a Simulated Dive
• The Simulator will enter Demo Surface Mode (Fig. 104)
upon ascending to 3 feet (1 meter) or shallower.
• Press and hold the Side (Select) button for 4 seconds to
access Time Acceleration. The small Time Clock icon will
begin flashing.
• Tap (press/release) the Side (Select) button to increase
Surface Interval Time 1 minute per real time second.
• Tap (press/release) the Side (Select) button during the Time
Acceleration to restore the time rate to normal.
• FO2 can be set 10 minutes after surfacing.
• Tap (press/release) the Front (Advance) button to access FO2
Set Mode. The FO2 graphic and value previously set will
appear with the value flashing.
• Press/release the Side (Select) button to increase the FO2
value in increments of 1%, or press and hold it to scroll.
• Tap (press/release) the Front (Advance) button to accept the
FO2 setting and return to Demo Surface Mode.
• To make another dive, press and hold the Side (Select) button
for 2 seconds to access Dive Mode.
• To revert operation to real Surface Mode, press and hold
Both buttons simultaneously for 2 seconds.
Fig. 104 - Demo Surface
Mode
DEMO
ATR
PSI
O
2
To Next Page
Loading...
