Need help?Do you have a question about the Octave v70se and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Inputs | 5 x RCA |
| Power Consumption | 300 W |
| Total Harmonic Distortion | < 0.1% |
| Input Impedance | 100 kOhm |
| Tube Complement | 4 x KT88, 2 x 12AX7 |
External precision trim pots and LED confirmation for monitoring output tubes.
Connector for optional capacitance modules to enhance power supply.
Details on line level inputs, phono option, and output connections.
System protecting components and saving power during idle periods.
Initial setup steps and safety checks before first use.
Prohibitions against opening the case and using qualified personnel for service.
Explanation of safety symbols and pre-connection voltage checks.
Recommendations for optimal and safe placement of the amplifier.
Conditions for maintaining the unit's warranty validity.
Procedure for unpacking the amplifier and verifying package contents.
Step-by-step guide on how to safely remove the amplifier's grille.
Guide to installing power tubes and first-time power-on with soft-start.
How to set BIAS and connect external audio components.
Visual guide to all available input and output connection possibilities.
Controls for power on/off and input signal selection.
Visual indicators and manual BIAS setting controls on the front panel.
Features for remote operation, status display, and volume adjustment on the front panel.
Controls and various audio input/output connectors on the rear panel.
Speaker terminals, AC power socket, fuse, and model identification on the rear panel.
Interface for connecting external Black Box units on the rear panel.
System for monitoring and protecting the amplifier from faults.
Circuit that extends component and tube life during switch-on.
Power saving mode that reduces heat and consumption when idle.
Input that bypasses volume control and output for subwoofers/bi-amping.
Procedure for removing the protective grille and tube placement diagram.
System for checking and adjusting output tube idle current.
Procedures and considerations for replacing and breaking in new tubes.
Information on the expected lifespan of amplifier tubes and their aging.
How to use the remote control for system components and volume adjustment.
Details on the optional phono board, its features, and specifications.
Details and connection of the external Black Box unit for power supply enhancement.
Details and connection of the Super Black Box unit for greater power supply enhancement.
Addresses problems like buzzing and hum from external sources and ground loops.
Troubleshoots hum from induction, clicks from switching power, and uneven channel levels.
Identifies issues arising from faulty or aging vacuum tubes.
Explains how faulty tubes activate protection or degrade audio performance.
Details on connectors, power output, frequency response, and tube configuration.
Preamplifier parameters, power consumption, weight, and mains voltage.
Visual representations of Total Harmonic Distortion and BIAS settings.
Graphs illustrating the amplifier's frequency extension and noise levels.
Answers on operating without speakers, recognizing faulty tubes, and tube lifespan.
Information on fitting tubes, loudspeaker impedance, and suitable audio cables.
To Next Page
