Odys NEO e100 - Error Code Description

25
V1.0.2
Error code description
Code
Error
Cause
Troubleshooting
1
Controller failed
Controller failed
Replace the controller
Off.
2
Motor reverb failed
1. motor reverb is
damaged
2. incorrect wiring
1. bad connection, plug it
back in.
2. replace the motor.
4
Undervoltage
protection
Battery empty
1 The error is automatically
rectified after charging.
2. replace the battery.
5
Overcurrent
protection
Long braking when
driving downhill with
a fully charged
battery
Stop driving and
let the appliance
cool down until the fault
is automatically rectified.
6
Brake lever failed
The brake lever is
pulled when
switched on or is
damaged
1. release the brake
lever.
2. replace the brake.
7
Throttle lever failed
Throttle lever is
pressed when
switching on or
defective
1. release throttle lever
2. replace throttle lever
3. release throttle lever
9
Timeout when
receiving
measurement data
Poor connection to
the display
1. check the wiring of the
display.
2 Replace the display.
3. replace the controller
10
Controller does not
receive any
measurement data
Poor connection to
the display
1. check the
wiring of the display.
2. Replace the display.
3. replace the controller
11
MOS overheated
The MOS has
exceeded the normal
operating
temperature
1. stop driving and allow
the device to cool
down until the fault is
automatically rectified.
2. replace the motor.
12
Overheated motor
The motor has
exceeded the normal
operating
temperature
1. stop driving and allow
the device to cool
down until the fault is
automatically rectified.
2. replace the motor.
13
Initialization of the
position sensor
failed
Poor connection to
the display
Replace the display
14
Vehicle has
overturned
Vehicle has
overturned
Put the vehicle
again