Odys Shark - Optical Input (OPTICAL IN); Troubleshooting Common Issues; Radio Sound Problems; Bluetooth Connectivity Issues

EN
ODYS Shark
- 12 -
11.3 OPTICAL INPUT
1. Connect a Digital Optical Audio Cable to the optical output on the audio
source and to OPTICAL IN on the unit.
2. Power on the unit and the audio source.
3. Press MODE button repeatedly to switch to OPT in Mode.
4. Audio from the connected audio source will now be played through the unit.
12 TROUBLE SHOOTING
Symptom Possible Cause Solution
Radio sound
distorted.
1. The station is not tuned in.
2. There is a poor signal in
the area.
1. Fine tune the station.
2. Unwind the wire antenna
for best reception
No radio sound. 1. The unit is not at tuner
mode.
2. The volume has been
muted or is on the
minimum setting.
1. Press MODE button
repeatedly until switching
to tuner.
2. Adjust the volume level or
press the MUTE button to
resume audio.
No Sound at
Bluetooth
mode.
1. The unit is not connected
with the audio source
device.
2. The unit is placed out of
the range
3. The volume has been
muted or is on the
minimum setting.
1. Follow the manual to
connect the audio source
device to the unit.
2. Relocate the unit within
Bluetooth operating range.
3. Adjust the volume level or
press the MUTE button to
resume audio.
Sound is
distorted at
Bluetooth/AUX/
Line in modes.
Sound source is distorted. If the original sound source of
the external device is poor
quality or with distortion and
noise, it will be easily noticed
with high-power speakers.
Try a different audio source
such as a music CD.
No sound at
AUX/Line in
modes.
1. The unit is not connected
the external appliance
properly.
2. The volume has been
muted or is on the
minimum setting.
1. Follow the manual to
reconnect the audio
appliance to the unit.
2. Adjust the volume level or
press MUTE button to
resume audio.