EN
ODYS Shark
- 9 -
8 BLUETOOTH OPERATING
8.1 Pairing
This unit can receive stereo audio signal from a BLUETOOTH stereo audio
source device.
1. Power on the unit, switch to BLUETOOTH mode by pressing MODE button
repeatedly.
2. LED indicator rapid blinking while it is pairing.
3. Enable the Bluetooth of the Bluetooth audio source device.
4. Pair and connect to ODYS Shark (MIB668A) on the audio source device. If
prompted for password, enter “0000”.
5. Pairing successful (LED indicator blue), ready to stream music.
6. During playback, press PLAY/PAUSE button to cease or resume the
playback.
7. During playback, press TUNING/SKIP/SEARCH FORWARD button to skip
to the next track; press TUNING/SKIP/SEARCH BACKWARD button twice
to skip to the previous track.
8. During playback, press and hold TUNING/SKIP/SEARCH buttons to search
through the current track forward or backward.
Note:
Pairing mode is cancelled after 1.5 minutes.
Pairing the playback device with the ODYS SHARK is only possible when
the ODYS SHARK is in the pairing mode and the LED blinks blue.
The above are generic steps to pair a BLUETOOTH device, for more
specific instructions on BLUETOOTH connectivity for your device, please
consult your manufacturer’s manual.
8.2 RE-CONNECT TO A BLUETOOTH AUDIO SOURCE
If the device is already paired with the ODYS Shark, but became unconnected
even with both Bluetooth devices turned on. You can re-connect them by
following steps:
1. Press and hold the PAIR button on the unit or on the remote to re-link the
audio source device. The Bluetooth indicator will blink for about 1.5
minutes for connecting.
2. Select the ODYS Shark (MIB668A) on the audio source device for
connecting. Bluetooth indicator will turn to solid blue if the ODYS Shark
(MIB668A) and the device have been re-connected successfully.
3. You can also re-connect the ODYS Shark (MIB668A) by using Bluetooth
operation of the device to be connected.
To Next Page
Loading...