EN
ODYS Shark
- 7 -
5 POWER SUPPLY
Plug AC plug into the outlet socket on the unit for connecting the main power.
NOTE: If not any audio signal inputs to the unit in about 10 minutes, the unit
will enter to standby mode automatically (except at FM mode).
6 Setup the unit
6.1 SLEEP TIMER SETTING
You can set the sleep timer at power on modes as following instructions:
During playback, press the SLEEP button on the remote control repeatedly to
cycle through the sleep time options, Release the SLEEP button when your
desired sleep time shows on the screen. Once the sleep time is expired, the
unit will be switched off.
During playback, press SLEEP button once to check the remaining sleep time.
6.2 HOW TO SET TIME
At the standby mode, press and hold the CLOCK button on the remote until
Hour flashes on the screen; use the TUNING/SKIP/SEARCH buttons on the
remote to adjust the hour and confirm your adjustment by pressing the
CLOCK button on the remote; Minute starts blinking on the screen, press the
TUNING/SKIP/SEARCH buttons on the remote to set the minute accordingly,
press the CLOCK button on the remote again to confirm your setting.
During playback, press and hold the CLOCK button on the remote to check
the current time.
Note: The time only could be set at standby mode.
6.3 TIMER SETTING
1. At standby mode, press and hold the TIMER button on the remote. The
hour on the display will begin blinking on the screen with the flashing timer
icon “T”.
2. Press the TUNING/SKIP/SEARCH buttons on the remote to adjust the
hour.
3. Press the TIMER button to confirm. The minute on the display will begin
blinking.
4. Press the TUNING/SKIP/SEARCH buttons on the remote to adjust the
minute.
To Next Page
Loading...