MINI6600
TM
Mobile Digital C-Arm Service Manual - Periodic Maintenance
APPENDIX A: Tool & Equipment List
Required Tools
In addition to common hand tools the following tools will be required:
Torx Screwdriver Set
1.5mm allen wrench
Jewelers Screwdriver Set.
Required Test Equipment
The test equipment required to complete the PM include:
Oscilloscope Tektronix 2236 or equivalent
Digital Volt-Ohm-Meter
Dosimeter (Keithley Model 35050, PMX II non-invasive meter or equivalent)
Model 96030 ion chamber
Resolution Tool, Converging Line Pair (LP/mm), OEC P/N 00-900860
Resolution Tool, Mesh (LP/Inch), OEC P/N 00-900040
Ion Chamber Positioning Fixture
Lead Apron
1 mm Copper Filter (3 each required), OEC P/N 00-877682
MINI6600/9600 Service Disk (software), OEC P/N 00-877444
Beam Alignment Tool, OEC P/N 00-879272
Canned Air, OEC P/N 88-299311
TP35 Cleaner, OEC P/N 88-299318.
To Next Page
Loading...
