What to do if the OHM TCS-C transmitter display is normal, but its operation is invalid?
If the OHM Receiver transmitter display is normal, but its operation is invalid, first verify that the receiver is powered on. Then, check the cable connectors to ensure they are properly connected. Finally, make sure the controlled equipment is started.
Why are the red and green power indicator lamps of my OHM TCS-C Receiver transmitter flashing alternately?
If the red and green power indicator lamps of the OHM Receiver transmitter flash alternately, it means that the Smart Card is not identified. Ensure the Smart Card is correctly installed and that its number matches the transmitter.
What to do if part of commands can not be normally operated on OHM Receiver?
If part of commands cannot be normally operated on your OHM Receiver, check if the receiver is properly connected. Also, inspect the cable and cable connectors for any issues, as the receiver might be damaged or the connection cable between the receiver and the controlled equipment may have failed.
Why is the OHM TCS-C Receiver transmitter status indicator lamp red and flashing with a buzzing sound?
If the OHM Receiver transmitter status indicator lamp becomes red and flashes once per second and is accompanied by sounds of the buzzer, this indicates a low battery level. Replace the battery with a fully charged one.
What does it mean when the red and green indicator lamps of the OHM TCS-C Receiver transmitter are normally on?
If the red and green indicator lamps of the OHM Receiver transmitter are normally on, it indicates that the high frequency module is not identified. Check whether the RF module is loose.
How to troubleshoot an OHM Receiver system with no response after starting the transmitter?
If the OHM Receiver system has no response after starting the transmitter, it might be due to insufficient power. Check the battery for damage or dirt on the contacts. If needed, insert a fully charged battery and restart the transmitter.
To Next Page
General