8
In general, the IOT of the sample scooter customer received defaults to test mode (red and
white flashing alternately); The IOT mode of mass production in transit is inactive; After receiving
the mass production and activating, the central control is in normal mode (white breathing light).
The difference of a demo sample and mass production
1. The functions of poking the pinhole are different.
Sample: Poke the pinhole on the surface of IOT for 2sec.
Mass production: Poke the pinhole on the surface of IOT for 5sec.
2. Demo sample (default test mode) and MP (default normal mode)
Test mode: flashing red and white breathing lights.
Normal mode: flashing white breathing lights.
Test mode: without vibration alarm.
Normal mode: with vibration alarm function.
Test mode: Supporting the way in which using USB cable and ZK_series ZK_series manage_tool to
send
command.
Normal mode: the way in which using USB cable and ZK_series ZK_series manage_tool to send
commands is
disabled. Only receive data from Bluetooth, NFC and server.
NFC and Bluetooth use the dynamic password and report it to the server for security.
Test mode is only available for our sample and for testing.
IOT Spare Battery
There is a spare battery inside the IOT, which is different from the main battery for powering
the scooter. Under normal circumstances, when the main battery has power, it will continue to
supply power to the spare battery until the spare battery is fully charged. When the main battery
is exhausted, the backup battery will supply power to the IOT to send background data.
In addition, a spare battery is used to support GPS operation after disconnection. In this case,
the emergency battery will report the location of the vehicle every four hours by default for about
15 days to help you determine the location of the vehicle. Please note that the emergency battery
does not need to be manually recharged. It is charged by the main battery and only works when
the main battery is exhausted.
To Next Page
Loading...
