18
Power Save sets how long the
printer waits before going into
standby mode. This saves energy,
but the printer requires time to
warm up when it receives a print
job or if you want to enter the
menu and change settings.
Setting the Power Save
Interval
1. Press + repeatedly until you see
SYSTEM CONFIG MENU on the
display.
2. Press E
NTER
.
POW SAVE TIME
60 MIN *
3. Press E
NTER
.
The second line of the display
starts blinking.
4. Press + repeatedly until the
value you wish to select (
5, 15,
30, 60 [default], or 240
minutes) appears on the
display.
5. Press E
NTER
twice.
The new setting is engaged and
the second line of the display
stops blinking.
6. Press O
N
L
INE
.
Disabling (or
Re-enabling) Power
Save
The printer comes set for Power
Save enabled. To disable (or
enable) Power Save
1. Press E
NTER
to enter Menu
mode.
2. Press - repeatedly until you see
MAINTENANCE MENU on the
display.
3. Press E
NTER
.
4. Press + repeatedy until you see
POWER SAVE
ENABLE†
5. Press E
NTER
.
The second line of the display
starts blinking.
6. Press + to toggle back and forth
between DISABLE and ENBABLE.
7. Press E
NTER
twice.
The new setting is engaged and
the second line of the display
stops blinking.
8. Press O
N
L
INE
.
Power Save
To Next Page
Loading...
