Oki C610dtn - Page 38

38 – C610/C711 User’s Guide
Network
Setup
(cont.)
NetWare Enable
Disable
Sets Enable/Disable of NetWare
Protocol.
EtherTalk Enable
Disable
Sets Enable/Disable of EtherTalk
Protocol.
Frame Type Auto
802.2
802.3
Ethernet II
SNAP
Sets the frame type.
Display Condition: Netware
should be enabled.
IP Address
Set
Auto
Manual
Sets the IP Address setting
method.
Display Conditions:
• TCP/IP should be enabled.
• IP Version is not IPv6.
IPv4
Address
xxx.xxx.xxx.xxx Sets the IPv4 Address.
Display Conditions:
• TCP/IP should be enabled.
• IP Version is not IPv6.
Subnet
Mask
xxx.xxx.xxx.xxx Sets the Subnet Mask.
Display Conditions:
• TCP/IP should be enabled.
• IP Version is not IPv6.
Gateway
Address
xxx.xxx.xxx.xxx Sets the Gateway (default
router) address. “0.0.0.0” means
that there is no router.
Display Conditions:
• TCP/IP should be enabled.
• IP Version is not IPv6.
Web Enable
Disable
Sets Enable/Disable of Web.
Enable: Web/IPP is available.
Disable: Web/IPP is not
available.
Display Condition: TCP/IP should
be enabled.
ITEM SETTINGS EXPLANATION