Version 1.0
1
Thank you for choosing OKI.
This is C712 configuration instructions for Ballot model. These instructions explain 2 ways for
configuration. Manually and using Ballot Configuration Tool.
Before ballot configuration, please perform the following steps.
1. Install Extended 2nd Paper Tray for 19" Ballots (Order/Part Number 44274505).
2. Turn ON the device.
3. Print the Configuration pages. (Print Information -> Configuration -> Execute)
4. Check Serial Number and the current tray 2 setting from the configuration pages.
[Serial Number]
[Tray 2 Setting (Paper Size)] (Before Ballot Configuration)
Notes: Be sure to note down the serial number as it is necessary for inquiry.
If you do not have Ballot Configuration Tool you can set by using device menu, please
proceed to next page. In case you have Ballot Configuration Tool, please proceed to page 3.
To Next Page
Need help?
General
