Network User’s Guide
86
5. Type 1 and press the Enter key. Perform the following
settings:
Please select (1- 99)? 1
No. Message Value
1 : TCP/ IP protocol : ENABLE
2 : IP address : 192.168.20.127
3 : Subnet Mask : 255.255.255.0
4 : Gateway address : 192.168.20.1
5 : RARP protocol : DISABLE
6 : DHCP/ BOOTP protocol: DISABLE
7 : Auto IP Address : DISABLE
8 : DNS Server (Pri.) : 0.0.0.0
9 : DNS Server (Sec.) : 0.0.0.0
10 : root password : “******“
11 : Auto Discovery Setup
99 : Back to prior menu
Please select (1- 99)?
6. Logout from the network interface. Turn the printer off
for about 15 seconds and on again to validate the
settings.
LPD Printing
Line Printer Daemon (LPD) is the most common protocol for
printing with TCP/IP to a network printer. Refer to the
workstation’s manual for details of lpr and lp commands. The
following explanation in this section uses the printing of print
file test.prn with printer name Myprinter_lp as an example.
To Next Page
Loading...
Need help?
General
