Introduction • 12
Self-Diagnostic Test
With the printer power switched on, press the print server test button
for more than three seconds and release. The self-diagnostic test
results (normally “OK”) and Network Information configuration
settings are printed.
The printout contains the following network information:
• Printer Information
• General Information
• TCP/IP Configuration
• NetWare Configuration
• EtherTalk Configuration
• NetBEUI Trap Configuration
• Email Configuration
• SNMP Trap Configuration
• IPP Configuration
• Time/SNTP Configuration
• Security
• Maintenance
NOTE
If “NG” is displayed for the self- diagnostic test instead
of “OK” see page 208.
To Next Page
Loading...
Need help?
General
