1
1-47 Setting up PostScript or PCL printing with Windows
ES3640e MFP EFI User’s Software Installation Guide - 47
Configuring installed options
After you have completed the printer driver installation, you must
configure the Fiery to reflect the options installed on the printer.
This allows the Fiery to take advantage of these options. You can
configure the options manually; or for TCP/IP network
connections, you can use the Two-Way Communication feature to
configure the options automatically.
Configuring installed options manually
The following procedure describes how to manually configure the
Fiery for the options installed on the printer.
To configure installable options on the Fiery from
the PostScript printer driver for Windows
2000/XP/Server 2003
1. Windows 2000: Click Start, choose Settings, and then choose Printers.
Windows XP: Click Start, and choose Printers and Faxes.
Windows Server 2003: Click Start, choose Control Panel, and then choose
Printers and Faxes.
2. Right-click the appropriate printer icon and choose Properties.
3. Click the Installable Options (PS) or Device Options (PCL) tab.
4. Select an installed option from the Available Options list.
5. In the PS driver click Add to move the option to the Installed Options list.
This is not necessary in the PCL driver.
6. Click OK to activate the current settings.
You are ready to connect to your network type (see the next
section “Completing the Windows 2000/XP/Server 2003
printer connection”).
Configuring installed options and updating print options
To Next Page
Loading...
Need help?
General
