Oki Hard Disk Drive User Manual

Troubleshooting> 77
T ROUBLESHOOTING
The network addresses used in this manual are shown for
example only. Network addresses used in your installation must
be generated from your own network.
S ELF - DIAGNOSTIC TEST
P RINTER DOES NOT PRINT
Ensure the printer emulation is set to PS or Automatic.
NG IS PRINTED IN THE SELF - DIAGNOSTIC TEST OR F LASH ROM C HECK
R
EGISTERS NG
Turn the printer off for 15 seconds and then on again.
Press the reset button on the rear panel, close to the network
interface to re-initialize it.
TCP/IP
C OMPUTER CANNOT FIND THE NETWORK INTERFACE CARD
Turn the printer off for 15 seconds and then on again.
Confirm the network interface is enabled on the printer.
Check there is a response to the PING command.
Check that the network cable is correctly connected and that the
green LED close to the printer’s network interface is lit. If not,
change the cable and try again.
Run the Self-diagnostic test.
Check the IP Address, Subnet Mask and Gateway are correct.
Check that the TCP/IP protocol is set to Enable.
Reset the network interface card to factory default settings.
If DHCP, BOOTP and RARP are not used, ensure they have been
set to Disable.

Oki Hard Disk Drive Specifications

General

Brand	Oki
Model	Hard Disk Drive
Category	Printer
Language	English