9
Re-enabling wired connection
Plug the network cable back in the LAN port ,the two led’s will not be on as currently the wireless
connection is enabled .
Press the settings button, press the down arrow until you see admin set-up, press enter
(you will be asked for a password which is 6 lower case a’s ) press the down arrow until you
see network menu, press enter, press enter on network setup, press the down arrow
until you see Enabling Wired Communications, press enter .
Press enter on yes and your wired connection will be re-enabled and your led’s will be
on again next to you LAN cable connection .
To Next Page
Loading...
