Getting started > 19
Plug and play installation
The MFP is a “dual device” - Windows sees it as a scanner and a printer. This means when
the MFP is plugged into a PC using a USB cable, you'll be prompted to install two different
drivers; the TWAIN (scanner) driver first and then the printer driver.
1. Attach the printer to a USB port of your computer.
2. Switch on the Printer.
3. Insert the Drivers & Utilities DVD.
If the DVD runs automatically, cancel the dialogue.
The ‘New Hardware Found' dialogue will display.
If you do not see the ‘New Hardware Found' dialogue, please check that power and
USB cables are connected properly, and the printer is switched on.
4. Install TWAIN driver first
b
c
a
d
To Next Page
Loading...
