Oki MB460 - Operation Time-Out

Access control > 59
2. Using the Down arrow key, highlight Yes and then press Enter to confirm.
The display reverts to the Enter PIN screen.
O PERATION TIME - OUT
When the MFP control panel is left inactive for a prescribed length of time (Operation Time-
out), the display automatically reverts to the idle screen if Access Control is disabled.
If an error state occurs, Operation Time-out is disabled.
After Operation Time-out, the display automatically reverts to the Enter PIN screen if
Access Control is enabled.
The length of the Operation Time-out depends on the setting in Menu Mode > Admin
Setup > System Setup > Return to Standby Time.
NOTE
When the MFP control panel is left inactive for a prescribed length of time, the
display automatically reverts to the Enter PIN screen if Access Control is
enabled.