45372301TH Rev.2
3-7 /
Oki Data CONFIDENTIAL
[D-1] Offset operation
When the offset is set, the position that paper is discharged to the stacker tray is shifted by a definite
unit, either in batch units or job units, to identify the separation of paper sets.
Fig. 3-6
[D-2] Stapler operation
When the stapler is set, the jogger moves the paper to the position it is stapled, the stapler motor (M9)
drives the stapler to staple the paper.
The stapler empty sensor (S13) detects when there are only a few staples and sends an alarm.
(Approximately 20 operations are possible after the alarm is sent.) The alarm is cancelled by refilling
the stapler.
Fig. 3-7
[1] Right side
[2] Stacker tray
[3] Paper
[1] Staple
[2]
[1]
[3]
(45
°)
5 ±2 mm5 ±2 mm
[1]
To Next Page
Loading...
