45372301TH Rev.2
3-8 /
Oki Data CONFIDENTIAL
[E] Stacker tray section
Fig. 3-8
Paper that is aligned in the finishing tray section is discharged to the stacker tray by the rotating ejector
belt which is driven by the ejector motor (M7). When paper is discharged from the processing tray, the
stacker tray is raised by the stacker motor (M8).
The SCU paddle tamps the trailing edge of the paper being discharged to the tray.
[E-1] Paper full alarm
The stacker tray lower limit detector switch (SW1) sends an alarm when it detects that the paper is
"Full" when the stacker tray is almost full of paper. (Approximately 50 sheets of paper can be added
after the alarm is sent.) The alarm is cancelled when paper is removed from the stacker tray.
[1] Ejector belt
[2] SCU paddle
[1]
[2]
To Next Page
Loading...
