Oki MC362 User Manual

- 80 -
Scanning to Local PC
4
Scanning
13 When the instruction to connect the
machine to the computer and turn on
the machine is displayed, plug the other
end of the USB cable into the computer’s
USB interface connector and hold down
the power switch for approximately one
second to turn on the power.
Note
● Do not plug the USB cable into the network interface
connection. Doing so may damage your machine.
14 Click the [Exit] button.
15 Remove “Software DVD-ROM” from the
computer.
The installation is complete.
 For WSD Scan Connection
To congure the Scan to Local PC via the WSD
Scan connection, follow the 2 steps below:
● “Step 1 Conguring the Network Settings of
Your Machine” P.80
● “Step 2 Installing Your Machine to the
Computer” P.83
Note
● You need to congure the network setting of the computer
before this procedure.
Memo
● You can skip the step 1 if the IP address is already set on
your machine.
 Step 1 Conguring the Network
Settings of Your Machine
Connect your machine to a network with an
Ethernet cable, and then congure the machine’s
IP address and other network information from
the operator panel. You can set the IP address
either manually or automatically.
If there is no DHCP server or BOOTP server on
the network, you need to manually congure the
IP address on the computer or machine.
If your network administrator or internet
service provider species a unique IP address
for the computer and your machine, set the IP
addresses manually.
Note
● When setting an IP address manually, ask the network
administrator or your internet service provider which
IP address to use. If the IP address is set wrong, the
network may go down or Internet access may be disabled.
● To congure the Scan to Local PC function via the WSD
Scan connection, follow these instructions.
- Conform the IP version of the machine to that of your
computer.
- Set [TCP/IP] setting to [Enable] on your machine.
(By factory default, it is set to [Enable].)
- Set [WSD Scan] setting to [Enable] on your
machine. (By factory default, it is [Enable]. If it
has been disabled, enable it by referring to the
Conguration Guide > “Conguring the scanning
to Local and Remote PCs” > “Using Functions for
Scanning to Local and Remote PCs” > “Enabling the
WSD Scan”.)

Oki MC362 Specifications

General

Print Resolution	1200 x 600 dpi
Fax Modem Speed	33.6 Kbps
Monthly Duty Cycle	45, 000 pages
Connectivity	USB 2.0, 10/100Base-TX Ethernet
Functions	Print, Copy, Scan, Fax
Duplex Printing	Yes
Memory	256 MB
Scan Type	Flatbed, ADF
Copy Resolution	600 x 600 dpi
Maximum Paper Size	A4
Dimensions	427 x 509 x 444 mm
Weight	29 kg
Paper Capacity	250 sheets
Operating System Compatibility	Windows, Mac
Scan Resolution	600 x 600 dpi