- 109 -
Printing from a Computer
5
Printing
For USB Connection
Follow the procedure below to connect a
USB cable and install a printer driver on your
computer.
Note
● You must be logged in as an administrator to complete
this procedure.
Memo
● You can skip this procedure if the printer driver is already
installed on your computer.
1 Prepare a USB cable.
A USB cable is not supplied with your machine.
Prepare a USB 2.0 cable separately.
Memo
● Use a USB 2.0 Hi-Speed cable for a USB 2.0 Hi-
Speed connection.
2 Hold down the power switch for
approximately one second to turn off the
power.
3 Plug one end of the USB cable into the
USB interface connector on the back of
the machine.
4 Turn on the computer.
5 Insert “Software DVD-ROM” into the
computer.
6 Click [Run Setup.exe] after [AutoPlay]
is displayed.
If the [User Account Control] dialog box is
displayed, click [Yes].
7 Select the language.
8 Select the device of your machine, and
then click [Next].
9 Read the license agreement and then
click [I Agree].
10 Read the “Environmental advice for
Users” and click [Next].
To Next Page
Loading...
Need help?
General
