MENU MODE > 36
Bottom Margin, Default = Valid
Change to Invalid if you want the printer to ignore the bottom margin
setting.
Busy Line, Default = SSD-
Appears only when the optional Serial Interface is installed. If Ready/
Busy protocol (factory default) is selected, you can choose which line
your system monitors for a busy signal:
l SSD -9V, select SSD-
l SSD +9V, select SSD+
l DTR -9V, select DTR
l RTS -9V, select RTS
Busy Time, Default = 200 ms
Appears only when the optional Serial Interface is installed. Sets the
length of the busy signal when the Ready/Busy protocol (factory
default) is engaged.
Busy Time Default = 200ms
Appears only when the optional Serial Interface is installed. Sets the
length of the Busy signal when the Ready/Busy protocol (factory
default) is enabled.
Centering Position, Default = DEFAULT
Used to limit printhead travel when printing narrow columns.
l Select Mode 1 for the narrow carriage printer.
l Select Mode 1 or Mode 2 for the wide carriage printer.
CAUTION!
Setting the Bottom Margin to Invalid can cause loss of data and
damage the printhead by allowing printing without paper.
To Next Page
Loading...
Need help?
General
