MAINTENANCE > 57
3.
Adjust the paper feed guides (1) for the width of the paper,
then place a sheet of paper in the separator. The paper will
feed into the printer.
NOTES
> If the paper does not feed in, remove it. Check the paper lever
position. Make sure the
ALARM
light is ON: if it is flashing, hold the
SHIFT
key and press the
CHARACTER PITCH/RESET
key. Reload the
sheet of paper.
> The factory default setting for the Top of Form (where the printing
should begin) is 1" down from the top of the page. To change the
setting, see “Top of Form (TOF)” in the previous chapter.
1
To Next Page
Loading...
