MAINTENANCE > 60
2.
Use the platen knob to back the paper all the way out of the
printer.
3.
Open the access cover (1) and remove the pull-up roller
assembly (2). Then grasp the tabs (3) on the sheet guide (4)
and lift it off the printer.
4.
Remove any torn pieces of paper.
5.
Fold some continuous form paper over three times to make a
page four sheets thick. Then, load it on the tractors and close
and lock the covers.
CAUTION!
Make sure the printer is turned OFF before you open the access cover.
1
2
3
4
3
To Next Page
Loading...
